As new superb sounding hand build point to point wired Dumble clone.

The amp has a Dumble inspired circuit, consisting of a clean channel or a clean channel combined with a second stage for a tube overdrive. This amp has a special option, a switch to switch from a non tone stack overdrive to a overdrive with the tone stack. This gives you the HRM effect .

The switch is a total bypass system. Get the best of both circuits in one amp!
You can get the 80's and the 90's tone.

The overdrive tone stack , drive, and clean channel trim are all adjustable from the outside of the chassis.
The fet channel trim is also adjustable from out side the chassis.

And for the power section, there is a half power switch (it is really in need as the amp is LOUD).

The bias system has a test point for each tube outside the chassis.

The amp comes with a built in *umblelator loop. This is a tube buffered effects loop of a notable circuit. There are send and retun pots and bright switches for both. It also has a true bypass.
Footswitch for the preamp boost and overdrive.
Front Panel: Fet and Normal inputs
Brite, Deep, Rock/Jazz and HRM switches
Volume
Treble
Middle
Bass
OD Mix
Overdrive
Level
Master
Presence
HRM-OD- treble, middle, bass adjustments
Pilot


Rear Panel:

Ground switch
Fuse
Mains, Standby and Half power switches
8 and 16 ohm speaker jacks
Effects send and return jacks
PAB and OD manual switches
Footswitch jack Send and Return controls with pull brite switches.


*umblelator loopt comes standard with a tube buffered, series loop, with send and return controls, and brite pull switches


Footswitch: With preamp boost and overdrive switches.


Transformers: Special wind fatstack output.

Tubes: four J/J preamp tubes four TAD, short bottle, black plate 6L6WGCs


Power: Full power -100 watts Half power - 50 watts


Supply power: 230 volts (also 115 volt) mains w/ 3 amp slo-blo fuse protection